Make sure to only use soft rubber pads that are easy to compress, so that it can allow the bolt to move backwards fully for proper loading/unloading of magazines and chambering of darts.Įxperiment with various plunger padding methods to help maintain the durability of AR removed blasters over long-term usage. The 20mm diameter soft rubber/foam pads i used in the above example are from a brand called 'Volkmar-Fix', they can be found at most common hardware shops. Nerf Modding 101: Recon CS-6: Hm nay ti s gii thiu cho bn cch thc hin c bn cho ngi mi bt u - sa i trung gian trong Nerf Recon CS-6 Cnh bo: Nu c thc hin khng chnh xc, sa i c th lm gim hiu sut hoc khin blaster khng th hot ng. In the following photo, soft rubber padding is attached to the base of the plunger. Therefore, padding should be applied to the plunger to help cushion the impact. Due to repeated direct impact on the bolt (hence the loud cracking sound during firing), many users of modded Recons have experienced bolts eventually punching a hole out of the back of the plungers! This results in very high wear and tear on the plunger, by both normal firing and dry firing. Without the AR, there is no air buffering system to cushion the plunger on bolt impact. Let the glue set properly before re-installing back into the blaster. Like most blasters, the range is about 30-35 feet. Step 4: Join back the 2 sections of the bolt sleeve using plastic hobby or epoxy glue. The Nerf N-Strike Recon is a great foam dart blaster which can be found for around 20. Very soon, the bolt will separate into two parts and the AR will just drop out. If it doesn't move, rotate the pipe cutter again, do not over-tighten the pipe cutter! Keep testing. Rotate the pipe cutter 2-3 times, and try to pull apart the bolt.

In the following photo, a pre-sliced cut has already been made for reference. Just tighten the pipe cutter slightly and do the rotational cut (not too much or else it might slice the bolt in half). That is the correct position to cut (though you can deviate 1mm either way). Please observe closely the spot where the pipe cutter blade is positioned at. The recon comes with a Nerf N-strike Recon. If you want to mod this gun you can see it in the mods page, recon.

You will need a rotational pipe cutter to cut the bolt in order to remove the AR. The Recon CS-6 is a dismountable blaster.

Step 3: This is the 'Pipe Cutter' method.

How to mod the recon cs 6